CCTV upgrading projects usually use rewiring cables, so it is long construction period, large cost and large difficulty. This is always a headache for installer and end-user, and actually the most difficult aspect of CCTV upgrading projects is slotted wiring.
Using original cable (analog system cable) to transmit Ethernet signal is very important. In original system, there are a lot of coaxial cable, power line, control line, audio cable and so on, and these cables can be still used, only add Ethernet extender at both ends of the cable, it can realize Ethernet signal long distance transmission.
Feasibility: Analog system upgrade into IP System, only change the front and rear equipments, Mini POE Ethernet Extender have the following features:
Max Transmission distance up to reach 600m (RVS 2×1mm2), can cover majority projects transmission distance
Max physical bandwidth reach 500Mbps, real-time bandwidth reach 88Mbps, fully satisfy 720P(2Mbps) and 1080P(4~8Mbps) camera transmission requirement
Support power and Ethernet over one cable transmission( 12VDC or 48~56VDC), can stratify PoE camera requirement
mini size, outdoor using,direct installation in camera housing, no need external equipment box
This solution can provide you the following convenience in projects:
Short construction period:
It saves the long period of cable trenching and wiring. After calculation, the construction cycle can generally save two thirds.
Small construction difficulty:
Users are using the original cables. So if they do the rewiring, it will affect their recent video surveillance. In some areas, rewiring is not convenient.
Small cost:
According to the user’s feedback, only a few workers are needed to do the installation and debugging when using Ourten Ethernet Extender solution and this can save average 45% labor cost.
Stable signal transmission:
The product adopts Qualcomm chip and goes through the EMC electromagnetic immunity test, so the transmission signal effect is very good, average delay 4ms, packet loss rate less than 0.5%.
